Amana MES96 U Series, Руководство по установке

Страница: 11 / 36

11
PVC ASTM STANDARD
SCHEDULE 40 PIPE D1785
SCHEDULE 40 CELLULAR CORE PIPE F891
SDR 21 OR 26 PIPE D2241
FITTINGS D2466
ABS
SCHEDULE 40 PIPE D1527
SCHEDULE 40 CELLULAR CORE PIPE F628
FITTINGS D2468
CPVC
SCHEDULE 40 PIPE F441
SDR 21 OR 26 PIPE F442
FITTINGS F438
POLYPROPYLENE
INNOFLUE® (CENTROTHERM)
POLYPRO® (DURAVENT)
PRIMER & SOLVENT CEMENT
PVC PRIMER F656
CPVC PRIMER F656
PVC SOLVENT CEMENT D2564
CPVC SOLVENT CEMENT F493
ABS SOLVENT CEMENT D2235
ABS / PVC / CPVC ALL PURPOSE
CEMENT (FOR PIPE & FITTINGS OF
THE SAME MATERIAL)
D2564, D2235,
F493
TRANSITION CEMENT FOR ABS TO
PVC or CPVC
D3188
INSTALLATIONS IN CANADA
PVC & CPVC PIPE & FITTINGS
PVC & CPVC SOLVENT CEMENT
TRANSITION CEMENT
INNOFLUE® (CENTROTHERM)
POLYPRO® (DURAVENT)
VENTING MATERIAL REQUIREMENTS
ULC S636
TABLE 2
Installation
This furnace is manufactured with 2” CPVC vent & intake
couplings. Use transition cement to connect PVC or ABS
pipe to these fittings. For furnaces requiring installation of 3”
pipe, the transition from 2” to 3” should be made as close to
the furnace as possible, and only when the piping is sloped
enough to prevent condensation from collecting.
This furnace must not be connected to Type B, BW, or L
vent or vent connector, and must not be vented into masonry
chimney. A masonry chimney may be used as a chase or
passage way for approved venting materials providing the
masonry chimney is not also being used to vent products of
combustion. Never common vent this appliance with another
appliance. Never use a vent which is used by a solid fuel
appliance.
Piping may run vertically or horizontally and must be ad
-
equately supported to prevent strain on joints, sagging,
separation, and detachment from the furnace. Horizontal
runs of piping must be supported every three to five feet.
Condensation within the furnace secondary heat exchang -
er and in the vent pipe is a normal occurrence. Vent pipe
must be installed to maintain a minimum 1/4 inch per foot
downward slope toward the furnace to return condensate to
the furnace’s drain system. Condensation may also occur
in the intake pipe. This commonly takes place during the
summer months when humid air enters an intake pipe that
runs through a cool basement or other conditioned space.
Refer to intake pipe options for using the RF000142 kit and
managing condensation.
T
O AVOID BODILY INJURY
,
FIRE OR EXPLOSION
,
SOLVENT CEMENTS
MUST BE KEPT AWAY FROM ALL IGNITION SOURCES
(
I
.
E
.,
SPARKS
,
OPEN
FLAMES
,
AND EXCESSIVE HEAT
)
AS THEY ARE COMBUSTIBLE LIQUIDS
.
A
VOID BREATHING CEMENT VAPORS OR CONTACT WITH SKIN AND
/
OR
EYES
.
WARNING
PREFERRED
Figure 4
TRANSITION NO LESS
THAN 45 TO HORIZONTAL
PLANE TO AVOID CREATING
A WATER TRAP IN VENT
PIPING.
°
ACCEPTABLE
Figure 5