A–5
RS2240003 Rev. 0
What is stage
cooking?
Stage cooking enables
several different cooking cycles, or
stages, to be used consecutively
without repeated input from the user.
Stage cooking can be set to to
defrost food initially, then cook it, and
then keep the food warm until
serving time. The total cooking time
for all combined stages cannot
exceed 60 minutes.
Programming Multiple Stages
Stage cooking allows consecutive cooking cycles without interruption.
Up to four different cooking cycles can be programmed into a memory
pad.
To use stage cooking:
1.
Follow steps 1 through 5 above.
6.
Press STAGE.
• This will begin programming for the next cooking stage.
• Display indicates stage to be programmed.
• Enter cook time and power level as in steps 4 and 5.
• To enter another cooking stage for that pad, press STAGE pad
again.
• Up to four different stages can be programmed.
• Total cooking time (all stages totaled) is 60 minutes.
7.
Press Quantity pad.
• CF:80 displays.
• Enter desired cooking factor by using numeric key pads (1 for
10% through 0 for 100%).
8.
Press PROGRAM SAVE to save the program and changes.
9.
To discard changes, press STOP/RESET before pressing
PROGRAM SAVE.
Programming Pads
Oven is shipped from the factory set for single pad programming. To
change the oven default to double pad programming, see
User Option
section. To program the amount of time or power level setting for a pad:
1.
ITEM
must flash in display.
2.
Press PROGRAM SAVE.
• Programming mode begins.
• Pro9
displays.
• Oven is in programming mode.
3.
Press pad to be programmed or reprogrammed.
• Display will change to review all settings for the pad.
• The pad number that is being programmed displays below the
word
ITEM
.
4.
Press TIME ENTRY to program amount of cooking time.
• Enter desired cooking time by using numeric key pads.
• Maximum cooking time is 60 minutes.
5.
Press POWER LEVEL to program level of microwave power.
• Press POWER LEVEL again to set to
H
(High).
• For a lower microwave power, press pads 1 (for 10%) through
9 (for 90%).
6.
Press Quantity pad if different cooking factor is desired.
• Default of CF:80 displays.
• Enter desired cooking factor by using numeric key pads (1 for
10% through 0 for 100%).
7.
Press PROGRAM SAVE to save the program changes.
8.
To discard changes, press STOP/RESET.
Example of Stage Cooking Conditions
Stage 1
Stage 2
Stage 3
Power
H (high)
3
9
Time
2:30
1:30
1:30
Mid-Cycle Pause
To add a pause to a programmed
cooking cycle
1.
Press HIDDEN PAD after
entering time or power level.
2.
LMT
displays. This indicates
the program is set for a mid-
cycle pause.
3.
Continue programming pad as
desired.
When programmed pad is used,
pause will occur in the middle of total
programmed time. Oven will beep
continuously and
PAUS
displays
until door is open and shut. To
continue cycle, press START pad.
What is a quantity cook
factor?
Each preprogrammed cooking cycle
can be set with a specific cooking
factor. The cooking factor is the
amount of extra time added as a
percentage of the original time. Each
time the quantity pad is pressed, the
cooking time will be increased by the
user-specified percentage. Amana’s
default cooking factor is 80%.
Operating Instructions for ASE7000, ASE9000, RC17S,
RC17SD2, RC17SED, RC22S, RC22S3, RC25S, RC27S, RC30S
Содержание ASE7000
Страница 37: ...A 1 RS2240003 Rev 0 Appendix A ...
