Amana ASE7000, Руководство по обслуживанию

Страница: 29 / 52

Disassembly
29 RS2240003 Rev. 0
To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitors
before following any disassembly procedure.
!
WARNING
Top Rear Magnetron
1. See “Component Location” Figure 2, for location.
2. Remove outer case and back panel.
3. Remove wires from TCO and magnetron.
4. Remove screws securing top rear exhaust duct to
cavity top. Do not attempt to remove exhaust duct at
this time.
5. Remove magnetron mounting nuts.
6. Remove magnetron and exhaust duct.
7. Remove allen screws securing magnetron thermal
cutout bracket to magnetron.
8. When replacing magnetron, verify wire mesh gasket
is reinstalled properly.
NOTE: Slide exhaust duct on magnetron before
reinstalling magnetron.
Top Front Magnetron
1. See “Component Location” Figure 2, for location.
2. Remove outer case and back panel.
3. Remove wires from TCO and magnetron.
4. Release center flow divider tabs from bottom flow
divider and tilt center divider upward.
5. Remove screws securing top front exhaust duct to
cavity top. Do not attempt to remove exhaust duct at
this time.
6. Remove magnetron mounting nuts.
6. Remove magnetron, exhaust duct, and center flow
divider.
7. Remove allen screws securing magnetron thermal
cutout bracket to magnetron.
8. When replacing magnetron, verify wire mesh gasket
is reinstalled properly.
NOTE: Slide exhaust duct and center flow divider on
magnetron before reinstalling magnetron.
Bottom Magnetron
1. See “Component Location” Figure 2, for location.
2. Remove outer case and back panel.
3. Remove wires from TCO and magnetron.
4. Remove screws securing bottom exhaust duct to
cavity bottom.
5. Lay oven on it’s left side.
6. Remove bottom access panel.
7. Remove magnetron mounting nuts.
8. Remove magnetron and exhaust duct.
9. When replacing magnetron, verify wire mesh gasket
is reinstalled properly.
NOTE: Slide exhaust duct on magnetron before
reinstalling magnetron.
Interlock Switch Module
1. See “Component Location” Figure 1, for location.
2. Remove outer case.
3. Disconnect wiring from interlock switch assembly.
4. Remove mounting screws securing interlock switch.
5. When replacing assembly, all wires must be
connected before operating oven.
NOTE: When the line fuse is blown interlock switch
module must be replaced.
7
8
2
4
3
5
Adjustment
1. To adjust interlock switch assembly, close door.
2. Loosen bottom and top screw on the interlock switch
assembly, allowing switch assembly to move in or
out.
3. With door closed, push forward on interlock
assembly to engage door latch. Then pull back on
interlock assembly until door is "snug" against front
oven cavity and tighten bottom screw first, then top
screw.
4. Door will remain latched when proper adjustment is
made.
NOTE: If door is not properly adjusted display will
indicate door when the door is closed.
Display Module
1. See “Component Location” Figure 1, for location.
2. Remove outer case.
3. Remove top touch panel, see “Top Touch Panel”
Assembly procedure.
4. Remove screws securing display module to top
touch panel.
5. Reassemble display module in reverse order.