RS5320016 Rev. 0
A–14
User Maintenance
WARNING
!
To avoid risk of burns or
electrical shock:
• disconnect electrical supply to
oven before changing light bulb.
• before replacing light bulb make
sure oven and bulb are cool.
• do not operate oven without
bulb and access cover in place.
CAUTION
!
Wear gloves to protect hands
from accidental bulb breakage.
1.
Disconnect electrical supply.
2.
Remove screw from access cover on top left wall of
oven exterior.
3.
While wearing protective gloves, unscrew the light
bulb counterclockwise.
4.
Replace light bulb with 230-volt (rated 250V), 40-watt
appliance bulb.
• Do not over tighten bulb or it may be difficult to
remove later.
5.
Replace light bulb cover and access cover before use.
6.
Reconnect power supply.
Replacing Oven Light
Service codes
During operation, the oven may display one of the following codes.
If this
should occur:
1.
Unplug oven and leave unplugged for approximately one minute. Plug
oven in and see if code reappears.
• If code does not reappear, continue normal use with the oven.
2.
If service code reappears, write down the service code displayed and
contact the nearest authorized Amana Servicer.
• Do not use oven until contacting the Amana Servicer.
Moving Oven Rack Guides
(some models)
The oven rack guides can be moved to one of three positions within the oven,
allowing for versatility in cooking and placement of food. The middle rack
position is the most common. Guides can also be removed for easier cleaning.
To remove rack guides:
1.
Oven cavity must be cool to touch.
2.
Remove oven rack by lifting up and sliding to the front of the oven.
3.
Apply gentle pressure by pulling upwards on the front of rack guide.
4.
Lift the rear of the rack guide to remove. Guide may be snug.
To replace rack guides:
1.
Oven cavity must be cool to touch.
• UP on guide rack should be in correct direction for placement.
2.
Place rear of rack guide over desired anchor in back of oven and push down.
3.
Place front of rack guide over desired anchor in front of oven.
• Apply firm pressure to front and rear of rack guide to fit onto anchor.
• Fit may be tight.
• Rack guide should not move after being set in place.
4.
Replace oven rack as desired.
• Slide oven rack towards rear of oven, holding upwards to avoid detents.
• Oven rack can be placed upwards or downwards. Upwards is
recommended.
• Oven rack must be seated in detents.
Oven Racks and Rack Hooks
(some models)
Clean oven racks and rack hooks with detergent diluted in warm water or in
dishwasher. Scrub with soft nylon pad to remove baked on material.
Do not soak rack hooks for an extended period of time.
NOTE: if the oven rack hook breaks do NOT use rack position.
Replace broken oven rack hook immediately.
Error Codes
Err1
E
rr2
E
rr3
E
rr4
E
rr5
E
rr6
E
rr7
Содержание ACE530
Страница 5: ...5 RS5320016 Rev 0 Important Safety Information ...
Страница 6: ...RS5320016 Rev 0 6 Important Safety Information ...
Страница 7: ...7 RS5320016 Rev 0 Important Safety Information ...
Страница 31: ...A 1 RS5320016 Rev 0 Appendix A ...
