Amada THIN-LINE 180 M Series, Руководство по эксплуатации

Страница: 19 / 44

CHAPTER 2: INSTALLATION
THIN-LINE
®
SERIES 180M WELD HEADS
990-133 2-3
5 Install the weld head mounting plate onto the weld head using the screws as shown.
6 Install the screws, washers, and T-nuts into the weld head mounting plate as shown.
7 If necessary, remove the end cap from the mounting post to expose the channels in the
mounting post.
8 Raise the weld head and mounting plate above the mounting post, insert the bottom T-nut
into the front channel of the mounting post, and slowly lower the weld head until you can
insert the top T-nut into the channel. Slide the weld head to the desired height, then tighten
the mounting screws.
9 If you are using an air head, install it on the rear of the mounting post following the
procedures in Steps 3 through 7.