Amada Delta, Руководство по эксплуатации

Страница: 8 / 40

DELTA TAU WORKSTATION
990-828 4
11.
Enable the laser if laser welding is desired. In NORMAL MODE, the laser will
automatically be set as enabled. In MAINT MODE, pressing the LASER ENABLE
button will enable/disable the laser. Indicator will be lit when laser is enabled. If
enabling needs to be controlled in the program, the variable P800 can be utilized.
Including the line “P800=1” will enable and “P800=0” will disable laser in a motion
program when that line is executed. Note that subsequent pressing of the LASER
ENABLE button will continue to toggle the enable/disable state.
12. When program execution reaches an M00, program execution will pause at. This is
typically used to allow a technician to modify a part location or confirm parts are set
properly. Jog buttons are enabled to align part under laser cross-hair. It is recommended
that this be done with LASER DISABLED. When it is desired to resume the program,
operator should press the CYCLE START button.
13. With the stage properly in place and a part correctly loaded it is now time to run your
program; this can be completed in two ways:
a. Hardware Panel Mode
b. Software Panel Mode
Please refer to the appropriate sections for additional information on how to run
programs (HARDWARE AND SOFTWARE PANEL MODES).
Machine Shut Down Procedure:
1. Remove
all parts.
2. Save any open programs
3. Exit all open computer programs including Deltamotion
4. Shut down the PC using the windows standard shutdown procedure
5. Turn off power at control panel.
6. Turn Laser Enable (KeySwitch) Off then turn off laser power
Emergency Stop Recovery Procedure
1.
Twist and pull the EMERGENCY STOP button.
2. Press the PROG STOP button which will enable the drives. The EMERGENCY STOP
button light will turn off.
3. If the Keyswitch is in the ‘Normal’ position and the door is open, homing stages may not
be permitted. Press the ‘Door’ button to close the door.