DELTA TAU WORKSTATION
990-828
3
NOTE:
If after pressing
PROG STOP
the
PROG PAUSE
button does not begin to
flash, check and make sure that all E-STOP switches have not been pressed
and are working properly and that door interlock indicates doors are closed.
5.
Power up computer and launch DeltaMotion application.
Note:
When power up windows there are three levels of login.
First: Engineer (password: eng).
Second: Technician (password: tech).
Third: Operator (password:
no password
). There can be up to 20 operator passwords.
These passwords can be changed to allow for secure access to the system
6.
Pressing both the
PROG PAUSE
and
PROG STOP
buttons simultaneously will cause each
stage to home. DeltaMotion should be connected to welding system prior to stage
homing. Homing will not proceed in
NORMAL MODE
unless door interlock indicates
doors are closed.
ANY ADDITIONAL APPLICATIONS PLEASE REFER TO ATTACHED
DOCUMENTS
7.
Once the homing has been completed the jog button lights will illuminate; this is the time
to power on the laser and turn the laser key switch.
8.
When the
Laser Ready
light turns green you can now begin the process of preparing your
parts and executing your programs.
9.
Before the execution of a program a part should be loaded in place. Some systems utilize
PIP sensors and cannot proceed unless a part is detected. Other systems utilize tooling
that might be damaged if the laser is permitted to fire upon it
WARNING:
BE SURE THAT THE PART IS LOADED
PROPERLY
WITHIN THE
AREA OF THE STAGE; MISPLACEMENT OF PARTS CAN CAUSE
SERIOUS
DAMAGE
TO THE WORKSTATION, FOCUS HEAD, AND THE PART ITSELF
10.
VERTICAL DOOR OPTION ONLY
: In most systems, it is possible to run programs
with or without the door closed. If you plan to run a program that will operate the laser,
you should make sure the door is closed before proceeding.
a.
Incorporate door open and close commands within your program.
b.
Use the button labeled DOOR to open and close the door.
Note that motion is typically enabled when the door is open. If this is not consistent with
your company’s safety policies, the stage can be disabled unless the door is closed. Also,
the MAIN/NORMAL mode select can be utilized as an over-ride if motion with door open
is sometimes required for technicians. Please consult AMYA factory for quotation of
upgrade if a field modification is required
Содержание Delta
Страница 33: ...DELTA TAU WORKSTATION 990 828 29 ...
