Ama Systems AMA EASY R5.01, Руководство пользователя

Страница: 17 / 32

2.4. FUNCTION 3: MOVING SENSOR SENSITIVITY
Send the following message to the AMA EASY: Fxxxx3=z
F = stands for FUNCTION
xxxx = stands for the password
3 = stands for the function type
z = stands for the status 0=switched off, 1= lowest sensivity, 2 to z = decreasing sensivity to value 9.
(7=default value)
Do not enter any spaces before or in your message. After about 45 seconds the AMA EASY will send a SMS
message to confirm.
2.5. HOW TO RESET THE DEFAULT VALUES?
Pull out the 2 A fuse of the fuse holder and disconnect the emergency battery from the AMA.
Place the jumper S2 (pic. 1).
Replace the 2 A fuse. Reconnect the emergency battery to the AMA. The device is under tension now.
Wait for about 10 seconds until the PDST LED starts to blink.
Remove the jumper S2 again. The AMA will reload the default values into its memory now.
2.6. HOW DOES THE AMA EASY WORK?
SWITCHING ON
Turn the ignition key in the OFF position.
60 seconds after removing the ignition key, the AMA EASY will automatic be armed. The PDST LED will blink
every 3 seconds.
SWITCHING OFF
If your vehicle is moved (lifted or replaced) the PDST LED will flash. The AMA EASY will give you 15
seconds (pre-alarm) to switch your ignition key into the “ON” position. Now the AMA EASY is switched OFF.
If the pre-alarm state is not canceled, the AMA EASY will send a message with the following information to
your cell phone:
AMA EASY R5.01
MOVING ALARM
CONTACT: OFF
BAT=OK SIG=4
GPS=0/1
TIME:201446
DATE:010707
50:55:34 N
005:26:31 E
SPEED:0.00
2.7. VERIFYING THE AMA EASY' STATUS
You can ask your AMA EASY for information anytime and anywhere.
Send the following message to the AMA EASY:
STATUS
The AMA EASY will send you the following SMS:
AMA EASY R5.01
PROG= 0,2,7,2,3
CONTACT: OFF
BAT=OK SIG=4
GPS=0/1
TIME:201446