alzaTools AT-CBCS20V, Руководство пользователя

Страница: 13 / 72

13 ENGLISH
• After starting the device, you can release the switch lock button (3).
Switching off
• Release the pressure on the on/off button (4) and the operation will stop.
LASER OPERATION
Never look directly at the source of the laser beam or its reflection from a surface and never point the
laser beam at anyone.
Each time the switch lock button (3) is pressed, the laser (7) switches on.
The laser beam allows better control of the cutting line.
The saw is equipped with a laser generator (7), which is used for precise cutting.
• Press the switch lock button (3).
• The laser begins to project a red line that is visible on the material.
• Make a cut along the line.
Dust generated during cutting can suppress laser light, so clean the laser generator lens from time
to time.
LASER ADJUSTMENT
The laser was set by the manufacturer. It may require adjustment only when the projected beam
deviates from the cut line.
• Press the switch lock button (3).
• The projected red line should be parallel to the defined cutting line. If the line is not in a parallel
position, turn the laser lens (a) left or right with a screwdriver until the projected red line is parallel
to the defined cutting line (Fig. H).
• If the projected red line is still out of the parallel position, turn the screwdriver (b) left or right until
the projected red line is in the parallel position (cross adjustment).
CUTTING
The cut line is defined by the cut line indicator (18) for an angle of 45° or (19) for an angle of 0° (Fig. I).
• Always hold the saw firmly with both hands when starting operation.
• Only switch on the circular saw when it is away from the material to be cut.
• Do not press too hard on the saw. The pressure should be moderate and constant.
• After cutting, allow the blade to come to a complete stop.
• If cutting is interrupted before the task is completed, start the saw and let it idle before continuing.
Wait until the tool has reached its full rotation speed, and then carefully insert the cutting disc into
the cut of the material being processed.
• When cutting perpendicular to the grain of the material (wood), the grains tend to rise and tear
(slow movement of the saw minimizes this effect).
• Make sure that the lower guard reaches its end position.
• Before starting to cut, always make sure that the depth of the cut arrest knob and the base bevel
adjustment knobs are tight.
• Only use cutting discs with the correct clamping hole and outside diameter for a circular saw.
• The processed material must be firmly clamped.
• Place the wider part of the saw base on the part of the material that will not be cut.
If the object is small, fix the processed material with F-clamps. If the base of the circular saw does not
move on the material being processed but is raised instead, there is a risk of recoil.
Properly clamped work material and firmly holding the tool ensure full control over the operation of
the power tool. This prevents the risk of injury. Do not attempt to hold short/small pieces of material
OPERATION