Alvarion BreezeACCESS SU-A-EZ, Руководство по эксплуатации продукта

Страница: 90 / 165

Chapter 5 - Command Line Interface Using the Command Line Interface
BreezeACCESS SU-A-EZ 73 Product Manual
5.1 Using the Command Line Interface
5.1.1 Accessing the CLI
When accessing the management interface via a Telnet connection, the SU-A-EZ
(CPE) unit can be managed by entering command keywords and parameters at the
prompt. Using the SU-A-EZ’s command-line interface (CLI) is very similar to
entering commands on a UNIX system.
5.1.2 Telnet Connection
Telnet operates over the IP transport protocol. In this environment, your
management station and any network device you want to manage over the
network must have a valid IP address. Valid IP addresses consist of four numbers,
0 to 255, separated by periods. Each address consists of a network portion and
host portion.
To access the SU-A-EZ through a Telnet session, you must first use the default IP
address 10.0.0.1.
1 From the remote host, enter the Telnet command and the IP address of the
device you want to access.
2 At the prompt, enter the user name and system password for the command
mode that you wish to enter. There are two command modes: admin mode
and installer mode. Admin mode allows you to configure most settings with the
exception of the regulatory domain. The regulatory domain may be configured
through the installer mode only.
3
The CLI will display the prompt for the mode you enter, for example Installer#
to show that you are using the Installer user account and ClientSta# for
priviledged access mode.
4 Enter the necessary commands to complete your desired tasks.
5
When finished, exit the session with the “exit” command.
After entering the Telnet command, the login screen is displayed:
To open a Telnet session: