TAS12-EDM & TAS12P-EDM Installation Instructions
Page 24
For Assistance: [email protected] +1 (909) 591-8431 PUD4005R1-0
Appendix A - Portable Base Turnstile
These supplemental instructions cover installation steps specific to portable base models only. When the installation is
complete, proceed to the Post-Installation Functions Check located on page 14.
Fig. A3
Fig. A4
Portable Base Plate Illustrated Parts List
Tools Required
Portable Turnstile w/ Base Plate
(Qty 1)
1.
Remove the turnstile from container packaging.
2.
Slide the guide rail into the support posts and
tighten the four (4) set screws using a 1/8"
Allen wrench [Figure A1].
3.
Attach the TAS12 unit.
Proceed to TAS12
Installation section on page 12.
4.
To maneuver the turnstile:
• Firmly grab the turnstile handle.
• Starting with the two (2) wheels on the cabinet
side, place foot on the top of the wheel lever
and push the lever to the down position
[Figure A3].
• Repeat for two (2) remaining wheels on hand
rail side.
• Roll the turnstile to the desired location.
• Using you hands, pull the four (4) levers to the
up position to lock the wheels [Figure A4].
Hand Rail
(Qty 1)
Also included
:
Hardware
• Hand Rail Set Screws
(Qty 4)
Electircal
• Neutrik Connector Kit
(Qty 1)
• 1/8" Allen Wrench
• 5/32" Allen Wrench
• 5/16" Open Wrench
• POZIDRIVE #1 Bit
• 7/8" Open Wrench
Lever up to lock
Lever down to roll
Fig. A1
Fig. A2
