TARGO DRIVES (TR SERIES)
|
ANTRIEBE TARGO (SERIE TR)
|
COMMANDES TARGO (SÉRIE TR)
5
PREPARATION FOR ASSEMBLY
88
463
121
149
М10
172
Ø
160
322
45
°
Ø
25.4
3
6.3
Figure 2.
Dimensions of TR-10024-400E / TR-13018-400E / TR-13012-400E drives
3.
PREPARATION FOR ASSEMBLY
• Please check the condition of all components and materials for their suitability and
compliance with the applicable regulatory documents in force. The applied instruments
and materials should be fully intact and comply with the safety norms, standards and
instructions in force.
• Please, make sure that the door construction is robust and suitable for the automation; that
it ensures easy movement of the door leaf during closing and opening. Please, make sure
that the door leaf is balanced, i.e. it remains immobile in any position if released.
• Please, make sure that there is enough space for mounting; in that the space around the
drive ensures easy and safe manual release.
• Please, make sure that the drive and its components are at a sufficient distance from any
heat source or open fire. The violation of this requirement can result in the damage of the
product, cause its malfunctioning, cause fire or other dangerous situations.
• Please, make sure that the surface of the drive system and its installation components are
solid and can be used as a reliable and rigid support. If this is not the case, take measures
to strengthen the installation locations.
• Please, make sure that foreign objects, water and other liquids are not present inside the
drive, if this is the case, disconnect the drive from the mains supply and consult the service
centre. The operation of the equipment in such condition is not safe.
• Please, make sure that an easy and safe way of operating the drive’s manual release, as well
as the use of the manual chain operated emergency control is ensured.
• Please, make sure that the mains supply is equipped with protective earthing.
