Alula BAT WIFI, Руководство по эксплуатации продукта

Страница: 5 / 23

4
Pre-Installation
Hardware Registration
Before installation of your BAT-WIFI, it must be registered at www.alarmdealer.com.
Here are the steps needed to register your hardware:
• Log into www.alarmdealer.com with the dealer login information that was emailed to you.
• Click Create Account Wizard
• Follow the 4-Step Wizard
Installation Guide
General Considerations
• Before installation, your BAT-WIFI must be setup using the dealer branded portal www.alarmdealer.com.
• The BAT-WIFI should be installed securely in the supplied plastic housing, and be mounted beside your
alarm control panel.
• Where available, proximity to the hard-wired Ethernet Internet connection should be taken into
consideration when routing wires.
• Choose a location with good reception by monitoring the BAT- WIFI signal strength LEDs with a
pre-wire power up.
• The BAT-WIFI must be completely powered down before starting the wire up.
• Programming is simple using the alarm control panel. Written instructions are included in the
“Wiring & Programming” section of this manual.
AP Configuration Tool QuickStart Guide
An easy to use QuickStart Guide has been designed to make the BAT WiFi easily join the customer’s WiFi
Network.
Connecting to a Wireless Network (AP Configuration)
The BAT-WIFI has an AP Configuration Tool which is designed to assist with ensuring the BAT-WIFI joins a
wireless network easily.
The following steps should be followed:
1. Power up the BAT-WIFI at the alarm panel.
2. Open your smartphone or laptop and search for Wireless Connections
a. In the list of WiFi connections you should see one labeled: IPD-CFG-AP-XX-XX-XX. The last six digits
will match the MAC address of your WiFi device. If not, try moving your BAT-WIFI to a different
location for better reception.
3. Connect to the WiFi Network: IPD CFG-AP-XX-XX-XX
4. After you are connected to your smartphone or laptop. Open a web browser and type in the following IP
Address: 192.168.100.1
5. Once you have connected to the above IP Address it will launch the AP Configuration Tool.
6. Next you will click on “Scan for Wireless Networks”. This will populate a list of all available wireless
networks in your area.
7. Find the customers Wireless Network and click on it. If security credentials are required, you will be
prompted to enter them.
8. You should now be connected to the customers WiFi Network!