Alula BAT WIFI, Руководство по эксплуатации продукта

Страница: 11 / 23

10
DSC Panel Programming
See Supported Panels section on page 24. All Control Panels must have a Phone Number in the Panel and an
Account Number in the Panel. As long as your Reporting Codes are in the Panel and are transmitting in Contact
ID it will send signals.
Programming when using TELCO (Recommended): General Concept Programming on DSC (BAT WIFI as Sole
Communicator):
Section BAT as Sole Communicator Code Summarization
301 Enter a Receiver Number
310 Enter Account Number
350 Enter ‘03’ to send Contact ID Panel default is ‘04’, SIA
Note: Ensure All Report Codes are in, and signals can be sent.
Programming ONLY when using PC-Link to send Signals (Not Recommended): DSC Programming for
Communications - GSM Emulation:
If GSM is used, it must be in dialer capture mode
Section
BAT as Sole
Communicator
BAT as Fail over
w/Add'l Communication
Device
BAT as Dual Reporting
w/Add'l
Communication Device
Code Summarization
015 Disable Option 7
If GSM, Disable Option
7 If Phone Line, Enable
Option 7
If GSM, Disable Option
7 If Phone Line, Enable
Option 7
Option 7 turns on/
off telephone line
supervision.
167 Set ‘060’ Seconds Set ‘060’ Seconds Set ‘060’ Seconds
Sets T-Link
acknowledgment delay
to 60 secs.
301 Set 'CAAF' Set 'CAAF' Set 'CAAF'
'CAAF' has to be set for
the panel to send signals
to the PC- Link
302 N/A N/A
Set 'Central Station
Receiver #'
Second telephone
number goes here.
303 N/A
Set 'Central Station
Receiver #'
Set 'Central Station
Receiver #'
This section is the
telephone backup of
section 301.
350 Set ‘04’ / ‘04’
Set ‘04’ / ’03 for Contact
ID, 04 for SIA FSK’ **
Set ‘04’ / ’03 for Contact
ID, 04 for SIA FSK’ **
Format sent as either
contact ID (03), or SIA
FSK (04). The PC-Link /
BAT can ONLY receive
signals via SIA FSK (04).