Alto VOICE plus, Руководство пользователя

Страница: 9 / 17

3.1.5 MASTER VOL. Section
Rotate this control to attenuate or boost the output level, which can be varied from - to +10dB.
32. MASTER VOL. Control
32
33
dB
MASTER VOL.
ON
OFF
POWER
MIC PREAMPLIFIER/
VOICE PROCESSOR
10
2
8
10
VOICE plus
OUTPUT LEVEL(dB)
CLIP 12 0 6 12 6
0
2
It will read the actual output level. The range goes from -12dB to +12dB. The CLIP LED will light up when
clipping distortion occurs in the circuit.
33. OUTPUT LEVEL Meter
3.2 Rear Panel
36 37 38
34
35 39
OUTPUT INPUT
RECORDING SEND LINE MIC
INSERT
MAIN
TIP
SLEEVE TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1 TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1 TIP
SLEEVE
AC INPUT
95-120V /210-240V 60-50Hz
Rated Power Consumption 20W
FUSE:
210-240V: T315mAL 250VAC
95-120V: T500mAL 250VAC
REPLACE FUSE WITH CORRECT
TYPE ONLY
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
RETURN
11 0-120V
220-240V
A101
2
1
3
40
This is a dual voltage unit. Before you attempt to connect and operate the unit, please make sure that your
local voltage matches the voltage on the fuse-holder cover.
Caution: The fuse protecting the AC supplies circuits of this unit. The fuse can only be changed by a
qualified technician, in the event of a fault or changing the supply voltage. If the fuse continues to blow
after replacing, discontinue use of this unit before repaired.
34. FUSE Holder/Voltage Selector
THIS IS SET FOR
110V AC TO 120V
AC OPERATION
THIS IS SET FOR
220V AC TO 240V
AC OPERATION
220-240V
110-120V
110-120V
220-240V
The fuse-holder above the AC connector on the rear of the chassis has 3 triangular markers(please refer
to the above pictures), with two of these triangles opposing each other, your unit is set to the operating
voltage printed next to these markers.
To change, pull fuse-holder out and rotate 180 , then push in again.
8