ALTHEN FDK Series, Руководство пользователя

Страница: 10 / 29

Notes:
- indication discreteness of 0.01mm is accessible only in a mode of direct indication;
- the separation point is indicated at the top side of the screen in the reverse indication
regime.
10.3. Image brightness set-up
To change the display brightness it is necessary to:
· turn the power on (press
Red button).;
· press Blue button and keep it pressed for more than three seconds;
· display will show " bt On " or " bt OF ";
· press Blue button again until “ brt X ” message appears on the display;
· choose the necessary brightness value by Green button pressings;
· to save the changed parameters press Red button the display shows “ SAUE ”
message, press the Green button to confirm saving and Red to cancel saving
of the changed parameters;
At brightness choosing one should take into account that increased brightness
enhances power consumption and decreases the period till battery recharge moment.
10.4. Millimeters-Inches -Tapes display set-up
To change the mode it is necessary to:
· turn the power on (press
Red button).;
· press Blue button and keep it pressed for more than three seconds;
· display will show " bt On " or " bt OF ";
· press Blue button again until the either “ SI ” or “ Inch ” or “ Tape ” message
appears on the display. “SI” – measuring results will be shown in mm, “Inch” –
measuring results will be shown in inches; “
Tape ” – measuring results will be
shown in tapes.
· choose the necessary value by Green button pressings;
Page 1 0/29