Altec ATP-23, Руководство пользователя

Страница: 12 / 29

12
Note:
* Please calibrate the gap/black mark sensor when changing media.
* Regular cutter specification:
Full cut: Paper thickness: 0.06 ~ 0.19 mm, 200,000 cuts
Partial cut: Paper thickness: 0.06 ~ 0.12 mm, 500,000 cuts
* Except for the linerless cutter, all regular/heavy duty/care label cutters DO NOT cut on media with
glue.
3.2.4 Loading the Thick Media (Thickness is 0.19 mm)
1. Open the printer top cover by pulling the tabs located on each side towards the front of the printer, and
then lift the top cover to the maximum open angle.
2. Remove the lower front cover.
3. Disengage the platen holder tabs from the lower inner cover by pulling out the right side and left side
tabs. Alter the both side tabs into the 90 degree position for thick label.
4. Reassemble the lower front cover in the reverse procedure.
5. Refer to section 3.2.1 to load the media.