Altai Technologies Ltd. All rights reserved
Altai A2n WiFi Access Point/Bridge Web-Admin Configuration Manual
TPS13-001_rev1.0
Figure 3-4 Internet Protocol (TCP/IP) Properties in Windows XP
3.2.
Check Access
“Ping” utility of Command Prompt is a handy tool to check the access to the A2n
Access Point.
1.
Go to the Command Prompt by typing “cmd” in “
Run
”.
2.
Type command:
Ping 192.168.1.222
The A2n Access Point shall respond to your ping request if A2n Access Point and
your PC have a correct connection.
NOTE:
Using the same PC to ping different A2n Access Point may cause ping failure.
This is because A2n Access Point has the same default IP address
but different MAC
addresses
. You need to type command “arp –d” in Command Prompt to clear ARP
table on PC before each ping.
3.3.
Configuration with Web-Admin
The A2n can be accessed through a Web Browser, for example, Internet Explorer
(IE).
1)
Open an IE session and type the IP address of the A2n Access Point. Example:
http://192.168.1.222
or
https://192.168.1.222
, where 192.168.1.222 is the A2n’s
IP address. The
default IP Address
is
192.168.1.222
.
