E32.0.93.6C-02 Manual for connection and operation of the JDI-22 page 10 of 10
9. Specification
Absolute maximum ratings:
see chapter 3.2. (Connection data)
Measuring input:
Pt100, 3-wire
Measuring range:
-50.0 ... + 200.0°C
(or -58.0 ... +392.0 °F)
Resolution:
0.1°C or 0.1°F
Accuracy:
< 0.3% FS ±1digit
(at nominal temperature)
Temperature drift:
< 0.015% FS / K
Max. perm. line resistance
:
20 Ohm
Measuring freq.:
approx. 4 measures / sec.
Display:
approx. 13 mm height, 4-digit red LED-display
Operating:
4 push-buttons or via interface
Interface:
serial interface, electrically isolated, connectable to RS232 with a level converter
Outputs:
2 volt-free Relay-outputs (standard)
or the corresponding designation on the label on the housing
Output 1:
make contact, breaking capacity: 5A (1A), 250 V
AC
Output 2:
change-over contact, breaking capacity: 10A (2A), 250 V
AC
Response Time:
< 0.5 sec.
Output-functions:
3-point
Switching points:
arbitrary
Power supply:
230 V
AC
, 50/60 Hz (standard)
or the corresponding designation on the label on the housing
Nominal temp.:
25 °C
Operating ambient:
-20 to +50 °C
Relative humidity:
0 to 80 % RH (non condensing)
Storage temp.:
-30 to +70 °C
Housing:
Dimensions:
48 x 96 mm (front-panel dimensions).
Installation depth:
approx. 115 mm (incl. screw-in/plug-in clamps)
Panel Mounting:
with brackets
Panel cut-out:
43.0
+0.5
x 90.5
+0.5
mm (H x W)
Connection:
via screw-in/plug-in clamps
Conductor cross-selection from 0.14 to 1.5 mm²
Protection class:
front IP54, with optional mounting seals IP65
EMC:
EA1 +A2 (appendix A, class B), additional errors: < 1% FS
When connecting long leads adequate measures against voltage surges have to be
taken.
The above-mentioned technical data was determined under laboratory conditions in accordance with the
relevant test regulations, in particular DIN standards. The data shown is guaranteed in this respect only. It is
the responsibility of the customer to ensure suitability for proposed application or for operating according to
conditions of use, we can offer no warranty in this range of use.
Subject to change without notice.
10. Disposal notes
This device must not be disposed as ‘residual waste’.
To dispose this device, please send it directly to us (adequately stamped). We will dispose it appropriately
and environmentally friendly.
