alpro Weekend-System II, Руководство по установке

Страница: 8 / 24

8
2.5. Instructions for installation
Before installation, a basic cleaning should be carried out (see chapter 1. page 4)
a) Switch off power supply of the treatment unit
using the main switch!
b) Close angle valve in the connection box and
relieve the water pipe system of the treatment unit
of pressure, e.g. by operating the multifunctional
syringe.
c) Fix a position for the Weekend-System II.
(see chapter 2.2)
d) Seek a suitable entrace into connection box of
the treatment unit or prepare it yourself (diameter
approx. 30 mm).
e) Connect the connecting lines of the Weekend-
System II to the treatment unit as described in
chapter 2.3 and 2.4.
f) Unscrew the screw in the turning knob of the
water stopn and remove the turning knob.
Remember the position of the turning knob.
Remove the cover!
g) Fit the pipes for water and compressed air at the
Weekend-System II:
1. First screw the outgoing pipe on the middle
supply.
2. Afterwards fit the incoming pipe to the water
stop.
3. Last insert the plastic tube into the quick
coupling.
When installing the device in the practice, secure
with a flat wrench (SW 21) when screwing the water
tubes to the device in order to prevent the
connections in the casing from being damaged.
h) Fit the cover and the turning knob again. Put the
turning knob into the same position as it was before
the dismantling (f)!
i) Open the angle in the connection box again and
switch on the main switch of the treatment unit.