8
-EN
Accessory List
• Head Unit ..................................................................................1
• Power Cable ..............................................................................1
• Mounting Sleeve ......................................................................1
• Carrying Case............................................................................1
• Bracket key ...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Remote Control ........................................................................1
• Owner’s Manual..................................................................1 set
Turning Power On and Off
Press
SOURCE
to turn on the unit.
Note
• The unit can be turned on by pressing any other button except
and
e
(Release).
Press and hold
SOURCE
for at least 2 seconds to turn
off the unit.
Note
• The first time power is turned on, the volume will start from level 12.
Source Selection
Press
SOURCE
to change the source.
TUNER
DISC
USB AUDIO/iPod
*1
AUXILIARY
*2
TUNER
*1
Only for CDE-142E/CDE-141E/CDE-141ETH, and only when
the iPod/iPhone is connected.
*2
Only when AUX SETUP is set to ON. Refer to “Setting the AUX
SETUP mode” on page 18.
Detaching and Attaching the Front Panel
1
Turn off the unit power.
2
Press
e
(Release) at the lower left side until the front
panel pops out.
3
Grasp the left side of the front panel and pull it out.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.
1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Adjusting Volume
Turn the
Rotary encoder
until the desired sound is
obtained.
Getting Started
Detaching
e
SOURCE/
Rotary encoder
Attaching
Controllable with Remote Control
This unit can be controlled with the supplied Alpine remote control.
For details, consult your Alpine dealer. Point the supplied remote
control transmitter at the remote-control sensor.
Remote control sensor
00ALPINE.book Page 8 Tuesday, October 16, 2012 4:13 PM
