9
-EN
Adjusting Volume
Turn the
Rotary encoder
until the desired sound is
obtained.
Setting Time
1
Press and hold
AUDIO
SETUP
for at least 2 seconds to
activate the SETUP selection mode.
2
Turn the
Rotary encoder
to select GENERAL, and then
press
ENTER
.
AUDIO
GENERAL
DISPLAY
iPod
BLUETOOTH
3
Turn the
Rotary encoder
to select the CLOCK ADJ mode,
and then press
ENTER
.
The time indication will blink.
4
Turn the
Rotary encoder
to adjust the hours while the
time indication is blinking.
5
When the hour has been adjusted, press
ENTER
.
6
Turn the
Rotary encoder
to adjust the minutes while the
time indication is blinking.
7
Press and hold
AUDIO
SETUP
for at least 2 seconds to
return to normal mode.
Notes
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold
ENTER
for at least 2 seconds after
setting the “hour”. Minutes will reset to “00”. If the display shows over
“30” minutes when you do this, the time will advance one hour.
• Pressing
will return to the previous mode.
• Pressing and holding
for at least 2 seconds will return to normal
mode.
• If no operation is performed for 60 seconds, the unit will return to
normal mode automatically.
Listening to Radio
1
Press
SOURCE
to select TUNER mode.
2
Press
BAND
repeatedly until the desired radio band is
displayed.
F1 (FM1)
F2 (FM2)
AM
F1 (FM1)
3
Press
TUNE
A.ME
to select the tuning mode.
DX SEEK (Distance mode)
SEEK (Local mode)
off (Manual mode)
DX SEEK
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press
or
to tune in the desired station.
Holding down
or
will change the frequency
continuously.
Presetting Stations Manually
1
Select the radio band and tune in a desired radio station
you wish to store in the preset memory.
2
Press and hold, for at least 2 seconds, any one of the
preset buttons (1 through 6)
into which you wish to store
the station.
The selected station is stored.
The display shows the band, preset number and station
frequency memorized.
Notes
• A total of 18 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote-control sensor.
Remote control sensor
Radio
SOURCE/
TUNE/A.ME
BAND
Rotary encoder
ENTER
Preset buttons
(1 through 6)
