10
Notes on individual parameters:
11-19 If you have a prefix set, the GSM gateway will only
release numbers starting with those digits. For others,
you will receive a busy tone. In this way, you can limit
calls only to the necessary networks or directions and
disable calls e.g., to the local telephone network (if you
then have only one prefix set, and this does not exist -
e.g. 0000 - all outgoing calls will actually be blocked and
the gateway accepts only incoming calls). If all memory
is empty, the numbers passing through the GSM
gateway will not be limited in any way (factory preset).
Prefix memories may not contain the full number of digits.
If you enter only one digit (minimum), wait for the
confirmation request, and confirm, the GSM gateway will
check only that first digit. Others in the order can no
longer be arbitrary.
Overwriting memory: Saving a new number to
memory erases the old prefix.
Delete memory: Delete memory by saving "nothing".
Enter only the memory number you want to delete,
wait for the confirmation request, and confirm.
22 An important function is to set the confirmation character (the
character that confirms the specified parameter speeds
up the choice, switches to prog. mode...). From the
factory, this character is preset
to „#". If the PBX uses
this character in conjunction with its functions, you can
change this character to "*" (you may need to make a
change without the PBX, with the phone connected
directly to the gateway input).
32, 35 GSM phones require a command to connect to the
inserted number. The GSM gateway sends this
command either immediately after entering the
confirmation character ("#") after the dialed number, or
after the time set by parameter 32 (this is actually the
time that the gateway waits for the next digit to dial). You
can also set the number of digits (parameter 35) after
