Alpha tools SBM 1000 E, Оригинальная инструкция по эксплуатации

Страница: 14 / 136

14
GBR
5.3 Fitting the drill bit (Fig. 5-6)
Always pull the power plug before making
adjustments to the equipment.
The quick-change drill chuck (1) is equipped with a
locking fastener:
To lock = press the sleeve (a) forwards
To unlock = press the sleeve (a) backwards
Release the depth stop as described in 5.2 and push
it towards the additional handle. This provides free
access to the chuck (1).
This hammer drill is fitted with a keyless chuck (1).
Open the chuck (1). The drill bit opening must be
large enough to fit the drill bit into.
Select a suitable drill bit. Push the drill bit as far as
possible into the chuck opening.
Close the chuck (1). Check that the drill bit is secure
in the chuck (1).
Check at regular intervals that the drill bit or tool is
secure (pull the mains plug).
6. Operation
6.1 ON/OFF switch (Fig. 7/Item 5)
First fit a suitable drill bit into the tool (see 5.3).
Connect the mains plug to a suitable socket.
Position the drill in the position you wish to drill.
To switch on:
Press the ON/OFF switch (5)
Continuous operation:
Secure the ON/OFF switch (5) with the locking button
(4).
To switch off:
Press the ON/OFF switch (5) briefly.
6.2 Adjusting the speed (Fig. 7/Item 5)
You can infinitely vary the speed whilst using the
tool.
Select the speed by applying a greater or lesser
pressure to the ON/OFF switch (5).
Select the correct speed: The most suitable speed
depends on the workpiece, the type of use and the
drill bit used.
Low pressure on the ON/OFF switch (5): Lower
speed (suitable for: small screws and soft materials)
Greater pressure on the ON/OFF switch (5): Higher
speed (suitable for large/long screws and hard
materials)
Tip: Start drilling holes at low speed. Then increase the
speed in stages.
Benefits:
The drill bit is easier to control when starting the
hole and will not slide away.
You avoid drilling messy holes (for example in tiles).
6.3 Preselecting the speed (Fig. 7/Item 8)
The speed setting ring (8) enables you to define the
maximum speed. The ON/OFF switch (5) can only be
pressed to the defined maximum speed setting.
Set the speed using the setting ring (8) on the
ON/OFF switch (5).
Do not attempt to make this setting whilst the drill
is in use.
6.4 Clockwise/Counter-clockwise switch
(Fig. 7/Item 6)
Change switch position only when the drill is at a
standstill!
Switch the direction of the hammer drill using the
clockwise/counter-clockwise switch (6):
Direction Switch position
Clockwise (forwards and drill) R
Counter-clockwise (reverse) L
6.5 Drill / hammer drill selector switch
(Fig. 8/Item 3)
Change switch position only when the drill is at a
standstill!
Drill
Drill / hammer drill selector switch (3) in the drill
position. (Position A)
Use for: Wood, metal, plastic
Hammer drill
Drill / hammer drill selector switch (3) in the hammer
drill position. (Position B)
Use for: Concrete, rock, masonry
6.6 Tips for working with your hammer drill
6.6.1 Drilling concrete and masonry
Switch the Drill/Hammer drill selector switch (3) to
position B (Hammer drill).
Always use carbide drill bits and a high speed
setting for drilling into masonry and concrete.
Anleitung_SBM_1000_E_SPK7:_ 18.07.2011 15:19 Uhr Seite 14