Alpha tools SBM 1000 E, Оригинальная инструкция по эксплуатации

Страница: 13 / 136

13
GBR
Hammer drilling into concrete (handle)
Vibration emission value ah = 13.192 m/s²
Uncertainty K = 1.5 m/s²
Hammer drilling in concrete (additional handle)
Vibration emission value a
h
= 10.910 m/s 2
K uncertainty = 1.5 m/s 2
Drilling into metal (handle)
Vibration emission value ah = 4.503 m/s²
Uncertainty K = 1.5 m/s²
Drilling in metal (additional handle)
Vibration emission value a
h
= 5.372 m/s 2
K uncertainty = 1.5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It may
change according to how the electric equipment is used
and may exceed the specified value in exceptional
circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
Do not overload the appliance.
Have the appliance serviced whenever necessary.
Switch the appliance off when it is not in use.
Wear protective gloves.
Residual risks
Even if you use this electric power tool in accordance
with instructions, certain residual risks cannot be
rules out. The following hazards may arise in
connection with the equipment’s construction and
layout:
1. Lung damage if no suitable protective dust mask is
used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or is
not properly guided and maintained.
5. Before starting the equipment
Before you connect the equipment to the mains supply
make sure that the data on the rating plate are identical
to the mains data.
Always pull the power plug before making adjustments
to the equipment.
5.1. Fitting the additional handle (Fig. 2-3/Item 7)
The additional handle (7) enables you to achieve better
stability whilst using the hammer drill. Do not use the
tool without the additional handle.
The additional handle (7) is secured to the hammer drill
by a clamp. During the handle clockwise tightens this
clamp. Turning it anti-clockwise will release the clamp.
The supplied additional handle (7) must first be
fitted. To do this, the clamp must be opened by
turning the handle until it is wide enough for the
additional handle to be slid over the chuck (1) and
on to the hammer drill.
After you have positioned the additional handle (7),
turn it to the most comfortable working position for
you.
Now turn the handle in the opposite direction again
until the additional handle is secure.
The additional handle (7) is suitable for both left-
handed and right-handed users.
5.2 Fitting and adjusting the depth stop
(Fig. 4/Item 2)
The depth stop (2) is held in place by the additional
handle (7) by clamping. The clamp can be released and
tightened by turning the handle.
Release the clamp and fit the depth stop (2) in the
recess provided for it in the additional handle.
Set the depth stop (2) to the same level as the drill
bit.
Pull the depth stop back by the required drilling
depth.
Turn the handle on the additional handle (7) until it
is secure.
Now drill the hole until the depth stop (2) touches
the workpiece.
Anleitung_SBM_1000_E_SPK7:_ 18.07.2011 15:19 Uhr Seite 13