Alpha Technologies GDI Bell, Руководство пользователя и программирования

Страница: 12 / 40

11
2. Switch on GDI
When all neccessary cables are connected (relay, locks, etc.)
CAUTION: antenna must be also connected. Then connect
speaker connector and connect PSU. The RED LED lights on
and after a while yellow LED start flashing (via table). The GDI
signalling by tones or by voice SIM reading, GSM network
registration and ready for operation (via table). Now you can
put on front panel of GDI but dont screw it.
When SIM is preprogrammed you can try first connection
–
push the button. The GDI must dial programmed phone
number. When SIM is not preprogrammed then first step is
SIM programming (via following article (3)) and then try
connection. After voice connection you can adjust setting of
speaker volume. Then screw up front panel of GDI.
3. Programm GDI parametres
The parametres in GDI ( must be switch on) you can
programm by 2 ways. By SMS or by PC ( special sw) via USB
port.
A) Programming by SMS.
Due security reasons you can programm GDI parametres from
authorised numbers only. They are saved on SIM under
names ADMIN1 to ADMIN9.
SMS are always written by BIG LETTERS
Each SMS elements are splited by space ( words). First word
is always command. Further word (s) is one or more
parametres.
Example:
INIT 420123456789
All commands are in appropriate table at the end of manual