11
2.3
Accessing Programing Mode
In o
rder to access “Programing” mode, consecutively execute the following actions.
1. Install the SIM card as shown in diag. 5.
Caution!
Prior to installing or removing the SIM card, it is necessary to de-activate the GSM Relay
Sensor Alarm Switch electrical supply! (i.e. install the protective plastic battery insert or remove the
battery).
2. Remove the Protective Plastic battery Insert from in between the contacts and the battery
(see diag. 5) or install a battery using correct polarity (if previously removed).
Diagram 5: SIM card installation and protective plastic battery insert removal
3. The GSM Relay Sensor Alarm Switch
LED indicator will glow red. The “GSM” LED will glow
for 3 seconds and will begin to flash quickly.
4. Wait for the SIM card to register on to the GSM network. At the conclusion of registration, 3
beeps will be heard and the “GSM” LED will flash (1) once every (4) four seconds. The GSM Relay
Sensor Alarm Switch LED indicator will glow green. This indicates that the GSM Relay Sensor
Alarm Switch
has entered “Programing” mode. During the entire duration of the “Programing”
mode, the LED indicator will glow green.
In the event the “GSM” LED continues to flash quickly, (the SIM card is not registering on the
GSM network) and might be due to the SIM card being incorrectly or not installed, blocked by a PIN
code or the GSM network is inaccessible (take steps in accordance with table 5).
Upon entering “Programing” mode, the GSM Relay Sensor Alarm Switch sends an SMS
notification with settings to the primary notification telephone number (if the primary number was
previously recorded in the SIM card memory).
For the span of (1) one minute, the GSM Relay Sensor Alarm Switch
remains in “Programing”
mode and stands by for an incoming call and/ or SMS containing any changes to the settings. In
the absence of an incoming call/ SMS, the GSM Relay Sensor Alarm Switch at the expiration of (1)
one minute enters “Armed On Guard” mode.
In the event of an incoming call/ SMS occurring and being accepted, the GSM Relay Sensor
Alarm Switch
at the expiration of (1) one minute, will enter “Armed On Guard” mode and will
transmit an SMS notification reflecting the setting changes to the primary registered telephone
number.
