12
2.4
Setting-up for First Time Use
After powering-up the GSM Relay Sensor Alarm Switch, a template with cells containing
default values will be created in the SIM card phone book (in accordance with table 4). Later on,
you are able to edit and alter these parameters and values.
It is necessary to record notification telephone numbers to the SIM card memory.
Perform the followings steps consecutively.
1.
Access “Programing” mode in the device (see item 2.3).
2. Begin by calling the GSM Relay Sensor Alarm Switch SIM card telephone number from the
telephone number that will be used as the primary notification number. After receiving and
recording the number, the GSM Relay Sensor Alarm Switch will disconnect the call and emit (1)
one audible confirmation beep. This number will be recorded in cell# 1 “1SMS” (see table 4) as the
designated primary number and will send an SMS notification from the GSM Relay Sensor Alarm
Switch
indicating “Setting Reset, Number Added +1xxxxxxxxxx”.
3. Proceed to record any additional notification telephone numbers by calling from each of them and
after each additional number is recorded, an SMS notification is sent to the primary telephone
number containing “Number Added+1zzzzzzzzzz”, “Number Added+1zzzzzzzzzz” etc.
4. One (1) minute after the last call is received, the GSM Relay Sensor Alarm Switch will transmit an
SMS containing the settings (see diag. 8) to the primary telephone number and will then enter
“Armed On Guard” mode.
If you were unable to record all the necessary additional notification telephone numbers, either
re-insert in the Protective Plastic Insert between the battery and contacts or remove the battery,
wait (2) two minutes and then repeat the procedure from the beginning- see item 2.6.
Diag.6- Sample SMS with Settings
2.5
Verifying Set-up
1.
While in “Armed On Guard” mode, close the contacts on terminal block X2 using a snippet of wire,
tweezers or a paper clip, etc..
2. The Relay Switch LED indicator will glow Red; the Relay Sensor Alarm Switch has recognized a
change in the position of the contacts (from “Open” to “Closed”) and will commence Notifications
3. Wait to receive an SMS notification containing
the text “Pcn ON” and an incoming telephone call
from the Relay Switch (acknowledge by disconnecting the incoming call).
4. After the concluding the notifications, the LED indicator will turn off and the Relay Sensor Alarm
Switch will re-
enter “Armed On Guard” mode.
1)
Primary notification number
14)
Frequency of
test/status notifications
GSM Relay Sensor
Alarm Switch number
Received from +1YYYYYYYYYY
1)+1XXXXXXXXXX,7)*100#,
14)7,18)1,26)Pcn ON,
27)Pcn OFF,36)1,SNN%
7
)
Balance Inquiry
18)
Notification
o
ption/
t
ype
36)
Notification language
Signal Strength
27)
Relay Pcn Contacts Open
26)
Relay Pcn Contacts Closed
