OWNER'S MANUAL OF SEEDING-DRILL AS1
Old Cod.Q00A00136
New Cod. MANT2010/00634 R.2
INSTALLATION
- 14
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
2) Mount the pre-assembled radar unit parallel to the ground between the two plates
with holes and secure it by inserting the screw C
3)
Block the arm with pin D as shown in the picture below
This way the radar works in its ideal position of ±37° in relation to the ground
(the height from the ground varies between 0.4 m. and 1 m.)
4.7.
ASSEMBLING THE SEED COVERING HARROW
When the AS1 seeder is delivered, the seed covering comb is supplied separately from the machine.
Together with the documents of the machine you will find also the Instructions Manual concerning the
following harrow: it is mandatory to follow it scrupulously
4.8.
ASSEMBLING THE REAR LIGHTS
When the AS1 seeder is delivered, the tables with rear lights and relative supports are supplied separately
from the machine. Inside the pack you will find the assembly instructions, which must be followed
scrupulously.
4.9.
ASSEMBLING THE SEEDER PIPES
When the AS1 seeder is delivered, the seeder pipes are supplied disconnected from the seed bar. It may be
obligatory to connect all the pipes, according to the bar that is to be connected (cutter or disc). Remember to
follow the instructions.
To connect the pipes to the bar:
1) Make sure that the hopper is connected
to the machine frame correctly
(see par 4.3)
2) make sure that the seed bar is
connected to the harrow roller correctly
3) Position the lower pin A of the roller
blade regulation for Alpego harrows
RK RH (see photo)
Never change the position of pin A.
Doing so could compromise pipe
RK
RH
