OWNER'S MANUAL OF SEEDING-DRILL AS1
Old Cod.Q00A00136
New Cod. MANT2010/00634 R.2
INSTALLATION
- 10
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
4.3.
APPLICATION ON HARROWS
Applying things to the tractor is a very dangerous operation. Be very careful to complete the whole operation
and follow the given instructions. The operation should be carried out on a horizontal surface with the seeder
in a stable position and on its support legs.
Proceed as follows:
To use the “ALPEGO” fast coupling/uncoupling system
correctly, make sure that the seeder is in a stable position
on its legs at a minimum height of 1.5m from the ground,
and that the position of the foot regulation holes is the
same as the drawing on the right. This is necessary for
keeping the seeder sloped forward, in order to favour fast
coupling.
Once the fast coupling frame has been assembled on the harrow (par 4.2)
move the tractor closer to the seeder.
Using the lifter, move into a position that is vertical to the front pipe of the
seeder frame.
Raise the harrow and hook it to the upper pipe.
Once the fast coupling C and the seeder frame E have connected, insert
and tighten the screws D M16X1.5X45 in order to lock the seeder to the
harrow frame.
Before tightening the screws completely, make sure that the seeder frame
rests correctly on the pins B.
Once this operation has been completed, the seeder is mounted sturdily
and safely to the harrow, therefore the support legs can be removed.
