OWNER'S MANUAL OF SEEDING-DRILL AS1
Old Cod.Q00A00136
New Cod. MANT2010/00634 R.2
INSTALLATION
- 12
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
1) Mount the two side plates with holes A and B which you will find in the package without blocking them completely on
the right-side seeding bar: this position coincides roughly with the position of the metering unit of the seed-drill
2) Mount the pre-assembled ground drive-wheel between the two plates
with holes. Insert the screw C M16x1.5 x 90 and tighten it so as to
guarantee a good oscillation of the wheel
Insert pin D under the supporting tube into one of the various holes. This is
useful in order to guarantee a minimum height from the ground necessary
when transporting the seed-drill.
Never insert pin D into the hole above the supporting tube to
block the oscillation: while the seed-drill is working this would
seriously damage both the gear box and the ground drive-
wheel
3) Connect the universal joint of the
ground
drive-wheel
with
the
distribution shaft and block it with the
appropriate pin
-
Align the hole of the free wheel of
the universal joint F with the rotation
shaft of the gear box and block it with
its appropriate pin.
-
Align the hole of the distribution shaft
with the hole of the universal joint
yoke G and block it with the
appropriate pin.
F