Almost Heaven Saunas AHBRL66RU, Инструкция по установке и эксплуатации

Страница: 23 / 50

11
EN
TREATING THE SAUNA
The lumber used in the construction of your Barrel Sauna is naturally resistant to the elements. Left untreated, the
exterior of an outdoor sauna will change colors. For example, a red cedar sauna will become silvery-gray. Rest
assured, it is fine to let the sauna weather naturally in this way. At any point in the future you can pressure wash (low
pressure only!) your sauna to bring back most of the original coloring.
If you want to retain the natural color of the lumber, your local paint store can recommend an outdoor stain. A clear
stain will retain the full natural color of your sauna. Be sure that is has a UV inhibitor so that it will best resist the
effects of sunlight. Be sure to follow the directions from the stain manufacturer for application instructions. Never treat
the inside of the sauna, and
never use varnish or paint on the exterior of the sauna .
If you have a red cedar sauna, here are a couple recommended stain types. However, be sure to test a small piece of
wood to be sure you like the color.
OPERATION
After the sauna has been installed, sweep down the inside to remove any sawdust and wood shavings, and then
vacuum completely. Using a damp cloth and warm water, wipe down the entire sauna, including the benches, to
remove any remaining dirt, dust and debris. Remove the corks from the drain holes to let any water drain out.
Replace the corks and leave them in place while using the sauna to minimize air flow. Rinse off the sauna stones
and install them in or on the heater in accordance with the heater manufacturer’s instructions. Improper placement
of heater stones can result in lower than desired heat temperatures. The first time you turn the heater on, set it to
the maximum setting and operate it for about 30 minutes with the door propped open. Then close the door and allow
your sauna to come up to the desired temperature.
If the sauna wood has absorbed moisture in storage, the staves may become loose after the intense heat causes
the wood to cure. It may be necessary to retighten the stainless steel bands periodically if this occurs. The lumber
will swell, especially if left in the open rain, and this will further tighten the seal of the wood.
The controls of the sauna heater are mounted at the bottom of the heater. The left dial is the temperature setting
and the right dial is the combined timer/on-off switch. Please refer to the manual that came with your heater for
full heater operational instructions. Since you most likely will use your sauna as both a “wet sauna” and a “dry
sauna”, you should install the sauna stones that have been included with the heater, following the manufacturer’s
instructions. These stones are necessary if water will be sprinkled on the heater to create the “wet sauna”, and
they will produce more consistent heating in the dry mode (without the use of water). It is common for a stone to
occasionally crack during initial heating. If excess amounts of water are used during sauna, prop door open to let
the humidity escape. Not much water is necessary to achieve a “wet
sauna”.
The amount of ventilation in the sauna can be adjusted by means
of the vent located toward the top of the sauna near the door. It is
important to have adequate fresh air flowing through the sauna, and
this flow can be adjusted with the movable vent cover. If the sauna is
located outdoors, you should keep the vent closed when the sauna is
not in use to prevent insects and rodents from entering the sauna.