Almost Heaven Saunas AHBRL66RU, Инструкция по установке и эксплуатации

Страница: 19 / 50

7
EN
BAND ASSEMBLY
Each of the Band Assemblies are made of the following components:
(1) Stainless Steel Bands with brackets
(2) 13 mm Nuts
(2) Black vinyl caps
(1) Threaded Rod
Place bands with pre-assembled brackets around sauna, spaced evenly apart. The two end bands should cover the
nails you used to hold the staves in place during assembly. Insert threaded rod through the bracket. Tighten nuts
evenly so that the bands are of equal tension. Before tightening nuts, check to make sure bands are still spaced
evenly.
Tighten nuts and install black vinyl thread protectors. (See Figure 3) You may place the brackets at the same level or
vary them at different heights depending on your styling preference.
Figure 3 - Band Assembly
Note:
● 1.8 m Barrel Saunas require three bands, the third band positioned in the center of the sauna.
● 2.4 m Barrel Saunas require four bands, the third and fourth evenly spaced along sauna length.
● 2.4 m Grandview Barrel requires five bands evenly spaced.