Almex T4PGF1, Инструкция по эксплуатации

Страница: 5 / 30

T4PGF1 INSTRUCTION MANUAL Page 5
SHAW-ALMEX INDUSTRIES LIMITED June 14 2017
4. SAFETY
Shaw Almex Highly recommends that all operators be properly trained by an Almex representative before using
any Almex equipment. This guarantees the full understanding of all safe operating procedures and functions of
the equipment. The material that is presented in this operating manual has been compiled to provide direction
for operating personnel so that the maximum effectiveness of the temperature control panel can be achieved and
so that there is a complete understanding of correct operating procedures. There is a key required to operate the
control panel and it should be in the possession of a qualified person.
Unqualified personnel must not open or
work on these units. Any unauthorized work or adjustments immediately VOIDS warranty.
PLEASE READ CAREFULLY
The following safety precautions should be read carefully and understood thoroughly before you set-up or
operate your temperature control panel. Failure to follow these precautions may result in personal injury and/or
equipment damage. All operating personnel should be trained in the proper operation of the temperature control
panel.
The risks associated with operating the temperature control panel are identified throughout this manual with
pictograms.
4.1. Definition of Pictograms
Electrical Hazard Burning Hazard
4.1.1. Electrical Hazard
1. A qualified electrician should perform all maintenance of the electrical components of the temperature
control panel.
2. All of the electrical components contain live circuits. Do not open or service any of the electrical
equipment without disconnecting the main power supply.
3. Incorrect voltage and phase may result in component damage and create a fire hazard. Check the serial
plate for ratings.
4. Equipment power supplies must be properly grounded or a severe shocking hazard may result.
5. Avoid using equipment in wet surroundings or a severe shocking hazard may result.
6. If any cable or connectors are damaged, they must be replaced or a fire and shock hazard may result.
4.1.2. Burning Hazard
There is not a burning hazard with the temperature control panel itself, however, improper use or component
failure could result in the vulcanizer overheating. Always use an Almex temperature control panel when
operating the vulcanizer and never leave the vulcanizer operating while unattended.
4.2. Limitation of use
This equipment has been designed to control the temperature of an AS/GF ALMEX conveyor belt vulcanizer
with the letters AS/GF in the model. The process of vulcanizing is done by applying a combination of heat and
pressure on the product for a certain period of time.
The T4PGF1 temperature control panel operates within a range of 32 ° F (0 ° C) to a maximum of 325 ° F (163 ° C).
Refer to the vulcanizer manual for platen limitations. An Almex temperature control panel must be used with an
Almex AS/GF vulcanizer and the vulcanizer should never be allowed to operate while unattended. Other use is
not allowed without the written permission of Shaw-Almex.