ALMAC Athena 870-BL EVO, Перевод оригинальной инструкции

Страница: 34 / 180

PAGE
34 ALMAC s.r.l.
2.10 Safety checks on the operation of the platform, to be performed
before use
The instructions given below must be followed.
•
With the platform in the transport configuration, place the machine with the
frame tilted with respect to the horizontal by a value greater than 0.5° on
the lateral. Operate the platform lifting control, make sure that the system
automatically brings the frame to the horizontal position
•
With the platform in the transport configuration, place the machine with the
frame tilted with respect to the horizontal by a value greater than 0.5° on
the longitudinal. Operate the platform lifting control, make sure that the
system automatically brings the frame to the horizontal position
•
With the platform in the transport configuration, place the machine with the
frame tilted with respect to the horizontal at the maximum angle both on the
longitudinal and on the lateral. Operate the platform lifting control, make
sure that the system automatically brings the frame to the horizontal position
•
Lift the platform without a load to the maximum height and then lower it a
few times; make sure that the machine works correctly
•
Check the operation of the anti-shearing device; this can be done by lifting
the platform to a height that involves an angle of the scissor frames greater
than 12° with respect to the horizontal and make sure that the descent
movement stops automatically at a scissor angle between 7° and 9° (the
vertical distance between the ends of the scissors must be greater than
50mm). Further downward movements are possible only after a 3s delay at
reduced speed.
Note: The platform is fitted with a
“
crush-preventing
”
system (ref. Point
5.4.4 EN 280), which gets enabled when the platform lowers and temporarily
blocks it to allow the operator to make sure there are no bystanders near the
machine.
•
Check the operation of the travel function with the platform lifted; this test
is performed by lifting the platform to a height that involves an angle of the
scissor frames of 23° with respect to the horizontal (maximum height of
transit area 4.5mt) and make sure that it is possible to travel with the
machine only at reduced speed (light indicator 2 flashing ). Also make
sure that at greater heights the light indicator (2) turns off and that it is not
allowed to move.