Alltech Keenan MechFiber350, Руководство оператора

Страница: 16 / 69

KEENAN
MechFiber350 and 370 Operator’s Manual
16
Revision D01 21
st
May 2019
7.2. Hitch height adjustment
The MF350 and 370 hitches have been designed to allow for various hitch height options with
the same components used. Hitch height is normally selected for the application and set at the
factory. However, if required, the hitch can be adjusted on-farm to level the machine. Some
options are shown below in Figures 6.1, 6.2 and 6.3.
The main standard hitch assembly is a bolt-on assembly, and once the main setting is
completed at the factory, it may also be adjusted on-farm by moving the assembly up or down
within the bolt holes, or turning the complete hitch over, as it is suitable to operate facing either
way up.
Note:
1: A minimum of four M20 x 100 mm Grade 8.8 bolts must be used to secure the swivel ring hitch and the clevis
hitch to the drawbar.
2: Care must be taken when adjusting the hitch height so that there is adequate PTO clearance and enough
ground clearance below the stand.
Figure 6.1: Standard hitch adjustment
Figure 6.2: High hitch adjustment
1300 range
Height adjustment available here
Tyre and or suspension deflection
Figure 6.1: Standard hitch adjustment
Figure 6.3: Clevis hitch adjustment
Figure 6.2: High hitch adjustment
Tyre and or suspension deflection
Tyre and or suspension deflection
Height adjustment available here
Height adjustment
available here
Clevis hitch eye
TÜV hitch eye
Swivel ring hitch eye