ALLPOWER EPW2000, Руководство пользователя

Страница: 15 / 24

ALL POWER™ EPW2000 POWER WASHER | 15
OWNER’S MANUAL | TROUBLESHOOTING 15
Problem Probable Cause Solution
When the switch is in the “I”
position the machine will not
start.
Electrical socket is faulty. Check plug, socket and fuses.
Voltage is inadequate. Check that the voltage is adequate.
GFCI trips. Reset/Try another outlet.
Power cord is not plugged in. Plug in power cord.
The pump does not reach
adequate pressure or
fluctuates.
Water Intake Filter is clogged Remove and clean filter
Pump is drawing air Tighten connections/bleed system
Suction valves are clogged/worn Clean or replace valves
Diameter of garden hose too small Replace with ¾ inch garden hose
Water supply is restricted Check hose for kinks or leaks
Insufficient water supply Fully open water source
The pressure washer has or
will not maintain pressure.
Excessive air in waterline and pump Turn unit and water supply off / Bleed system / Hold trigger down
TROUBLESHOOTING GUIDE
The following troubleshooting guide is recommended for basic or
common problems; if there’s an issue with the generator that is not
listed, please call 1-888-896-6881.
NOTE: Troubleshooting problems may have similar causes
and solutions.