AllPondSolutions JY Series, Инструкция по эксплуатации

Страница: 13 / 17

·
When topping up tank water it is essential to add the appropriate amount of
dechlorinator or water conditioner; not just adding water from a tap.
·
Do not leave lights on for more than 6-8 hours as over-usage may result in
hard to tackle algae issues.
·
Regularly use a soft algae pad to clean interior of the tank. Magnet cleaners
should not be used as if sand or substrate becomes caught under the pad
this can scratch the acrylic.
In general, it is recommended to disconnect your unit and clean the pipework,
impellers and filter media monthly. Pipework will become blocked with waste
and protein slime over time, so regular cleaning is important for optimal
performance.
To clean the outside of the tank, you can periodically wipe with a damp cloth
(use a cloth dampened with water from your aquarium, never use any chemical
products or detergents). Lemon juice can also be used to removing any
limescale build-up. Rinse thoroughly afterwards to remove any acidic residue.
It is vital that O-rings are regularly inspected and replaced as the rubber
watertight seal will perish over time, which may cause your canister to leak.
Before replacing your o-rings, ensure they are well lubricated.
O-rings
A clogged impeller is often the primary cause of many operational faults, so it
is extremely important to clean and inspect your impellers every month to
ensure they are functioning correctly and remove any debris. Keeping the
impellers clean will improve the performance of your equipment. The impeller
itself is a perishable part and will be subject to wear and tear overtime. As a
result, it is also very important to replace your impeller and ceramic shaft
annually.
To clean, simply wash with your aquarium water (from a water change) - whilst
doing this you will be able to check that the impeller and shaft are both in
good condition. When returning this to the motor head ensure this is seated
correctly with the two rubbers on either end of the shaft (sometimes the
Impellers and Shafts