Connecting to the Alloy SmartHome Hub
The Alloy SmartHome Hub (henceforth the Hub) is accessible via WiFi and cellular networks.
To access your Hub via WiFi, you first need to connect to your Hub’s own access point. This will
allow you to edit initial WiFi connection settings:
● Make sure that your computer is WiFi-enabled and that is not otherwise connecting to a
network.
● Start the Hub by connecting it to its power supply.
● Wait for the LED to turn from blinking red to blinking orange.
● Press the button just above the LED for at least 5 seconds; this puts the Hub into Access
Point Mode. The LED light will go from blinking green/red to steady orange.
● An SSID starting with srh (e.g. srh180517024) will soon appear to your computer’s WiFi
access manager (if in range).
● Select this access point. No password is required to connect to it.
● In your browser, enter the address
● After the page opens, select an SSID, enter its password and apply the configuration.
● Press the complete button when it appears.
● The LED light on the Hub should eventually turn steady green.
● On your computer, select the same WiFi access point you configured your Hub with.
Accessing the Alloy SmartHome Hub Web
application
● Find the serial number of the Hub (something like
SRH176390014
). You may already
know it as it is the name of Hub’s access point (see above). The serial number also
appears below the barcode on the label attached to the underside of the Hub.
© 2020 Alloy SmartHome LLC All Rights Reserved
2
