page 3 of 5
v1
®
®
Installation Instructions
Also be sure that the end with the lip is on the correct side.
Refer to the image to the right.
c) Place the Silicone Insert into the gap between the lens and
the diodes. This will ensure a snug connection.
d) Slide the prongs between the PrimaLine Neon Tape Light
and plastic backing. Be sure the prongs are in contact with
the metal connection pads on the back of the PCB of the
tape light (the side without diodes).
To maintain the correct polarity, be sure that the plastic
protrusion on the connector is on the same side as the tape
light diffuser.
Note: If polarity is incorrect, the PrimaLine Neon Tape Light
will not illuminate when connected to power. To correct this,
reverse polarity at the power supply.
e)
Secure the metal clamp over the tape light and squeeze
prongs to ensure a tight connection (adjacent to the rubber
washer). Orient the metal clamp so that the notch on the
outside is furthest away from the prongs.
Notch
Insert Prongs
Here
Plastic
Backing
End with Lip
Connects to Power
Plastic Protrusion
Diffuser
Place Silicone Insert
Here
Specifications subject to change without notice.
www.AlloyLED.com | Call: 800.910.LEDS [5337] | Text: 510.400.6690 | [email protected]
