Figure 6 (PPPOE Connection Setup)
To complete the connection you must now click the
apply button. The apply button will temporarily
save this connection. To make the change perma-
nent you need to click on Save Setting (at the side
of the page). At the system commands page, click
on Save All.
4.4.1.4 DHCP Connection Setup
Dynamic Host Configuration Protocol (DHCP) allows
the ADSL Router to automatically obtain the IP
address from the server. This option is commonly
used in situations where IP is dynamically assigned
and is not known prior to assignment.
To configure the ADSL Router for a DHCP connec-
tion, click on Setup and then click on New
Connection. The default DHCP connection setup is
displayed. At the Type field select DHCP and the
DHCP connection setup page is displayed; figure 7
illustrates a typical DHCP configuration. Give your
DHCP connection a unique name; the name must
not have spaces and cannot begin with numbers. In
this case the unique name is called DHCP1. Select
the encapsulation type (LLC or VC); if you are not
sure just use the default mode. Select the VPI and
VCI settings; your DSL service provider or your ISP
will supply these; in this case the DSL service provi-
der is using 0,100. Also select the quality of service
(QOS); leave the default value if you are unsure or
the ISP did not provide this information.
If your DSL line is connected and your DSL/IPS provi-
der is supporting DHCP, you can click the renew but-
ton and the gateway will retrieve an IP address,
Subnet mask, and Gateway address. At anytime,
you can renew the DHCP address by clicking on the
renew button; in most cases you will never have to
use this button.
Figure 7 (DHCP Connection Setup)
To complete the connection you must now click the
apply button. The apply button will temporarily
save this connection. To make the change perma-
nent you need to click on Save Settings (at the side
of the page). At the system commands page, click
on Save All.
4.4.1.5 Static Connection Setup
Static is used whenever a known static IP is assig-
ned. The accompanying information such as the
Subnet mask and the gateway should also be speci-
fied. Up to three Domain Name Server (DNS)
addresses can also be specified. These servers would
enable you to have access to other web servers.
Valid IP addresses range is from 0.0.0.0 to
255.255.255.255.
To configure the ADSL Router for a Static connec-
tion, click on Setup and then click on New
Connection. The default Static connection setup is
displayed. At the Type field select Static and the
Static connection setup page is displayed; figure 8
illustrates a typical Static configuration. Give your
Static connection a unique name; the name must
ALL 0333AU – DSL ETHERNET MODEM ROUTER
A L L N E T
®
2 0 0 4
9
ALL0333AU_Manual_a 07.04.2004 14:12 Uhr Seite 9
