Allmatic B.RO X40 DISPLAY, Инструкция по эксплуатации

Страница: 25 / 80

5/20 6-1620020 rev.2 10/01/2019
ITA ENG FRA ESP DEU POR
ENG

Make sure that the receiver is out from any menu.
The display shows:
Press briefly the MENU button.
The display shows:
 

Select the location of the transmitter in the memory with UP (+) and
DOWN (-) buttons of the receiver.
The display shows:
Otherwise, if the remote is already memorized in that location, the display shows:
With UP (+) and DOWN (-) buttons it is possible to change the location where a
transmitter is stored.

Press a key of the transmitter.
The display shows:
Otherwise, if the remote is already memorized, the display shows:



Press and hold the MENU button until the display shows:
if the key is already memorized, the display shows the previous function of the
key:
Select the function of the key with UP (+) and DOWN (-) buttons.
  

Press and hold the MENU key until the display shows:
Enable/disable the key of the transmitter in the channel 1 with UP (+) and
DOWN (-) buttons of the receiver.
If the key is enabled, the display shows:

3.3 - ADVANCED LEARNING
The advanced learning memorizes the single key of a transmitter.
During the learning phase it is possible to set the parameters of the memorized remote control. See paragraph
4 for more information
about single parameters.
The receiver exits from the learning phase after 10 seconds of inactivity or with the press of the MENU button.