Allmand Maxi-Power MP65-8B1, Руководство оператора

Страница: 19 / 55

18 ALLMAND.COM
Operating Procedure
1. Start the generator unit and adjust the frequency
and voltage as outlined in Manual Operation .
2. Turn the starter switch to the STOP position to
stop the engine.
3. Turn the main circuit breaker, as well as the
circuit breaker of any receptacle connected to a
load, to the ON position.
4. Turn the operating selector switch on the control
panel to the AUTO position, and turn the engine
speed switch to the HIGH position.
5. The unit is now in stand-by mode, and will start
once the start signal is sensed. See Function .
Function
• When the start signal activates in stand-by mode,
it starts the unit. (This includes preheating.)
• When the stop signal activates, the unit continues
to operate for a cool-down phase, then the unit
stops and is placed again in stand-by mode.
Starting Action
• The unit will attempt to start over three 10-second
intervals, with an 8-second break (including
preheating) between attempts. If after the third
attempt the unit will not start, an indicator light
will light, indicating the problem. See Meters and
Indicator Lights during Operation ; see also
Troubleshooting .
• If the OVERCRANK indicator light turns on,
immediately press the emergency stop button.
See Emergency Stop .
NOTICE Failure to press the emergency stop
button when the OVERCRANK indicator light
turns on may result in engine damage.
Go
to
Discount-Equipment.com
to
order
your
parts