Allmand Maxi-Lite II, Руководство по установке

Страница: 9 / 44

9
en
English
4a
Distribution Block 1
Distribution Block 3
E
Distribution Block 2
Zettler Relay
Disconnection Detail
4b
E
Zettler Relay 2
7. Cut off and discard the female spade terminal from
the wire that was connected to the Zettler relay. Strip
off the appropriate amount of wire insulation and crimp
a yellow fork terminal ( F , Figure 5, Ref. 7) onto the
wire.
5
F
8. Loosen the screw on AC post 1 of 725 light relay 1
and connect the new fork terminal on the wire ( G ,
Figure 6a-b) removed from either Zettler relay 1, 2, or
3 into the post. Tighten down the screw onto the fork
terminal.
9. From the kit contents, locate and select the blue 10
AWG wire ( H , Figure 7, Ref. 5) that matches the color
of the wiring from Zettler relay 2. For Zettler relay 1
select the red 10 AWG wire (Ref. 4), and Zettler relay
3 select the black 10 AWG wire (Ref. 6). Cut the
selected 10 AWG in half, and strip the ends of the
cut wires. On one of the cut wires crimp a yellow fork
terminal ( I , Figure 7, Ref. 7) on one of the ends. Set
aside the other cut wire as it will be used in Step 16.
6a
725 Relay
Connection Detail
6b
G
725 Relay 1
725 Relay1
G
Not for
Reproduction