Allied HO-PAC 1000 Series, Техническое руководство, Страница: 31 / 50

1000 Series Ho-Pac
11.7.2 Bearing Installation
1. Thoroughly clean the bearing housing
and eccentric shaft.
2. Apply a light coating of oil to the
bearings prior to assembly.
3. Slowly press the bearing into the bearing
housing (interference press fit). Apply
contact pressure to the outer race only.
4. Install one bearing and housing onto the
eccentric shaft (close tolerance slip fit).
5. Align in main housing.
6. Repeat with other bearing and housing.
7. Install spacer and gasket.
8. Install hydraulic motor.
!! CAUTION !!
Follow bolt torque specifications. Refer
to Section 11.6.
9. Install hydraulic hoses.
10. After completely assembled, follow
lubrication procedures; refer to Section
11.5.
11.8 Spring Mounts
The spring mounts are subject to aging and
require periodic replacement. While mount
life depends primarily on use, extreme
environmental conditions and other factors
can shorten mount life.
If multiple mounts are to be replaced, it is
recommended to completely replace one
mount at a time.
1. Position Ho-Pac on flat, stable surface.
2. Adequately support or block the
mounting frame to relax mounts.
!! WARNING !!
Do not place hands or fingers between
mounting frame and base plate during
removal of spring mounts or mount
nuts.
3. Loosen all nuts prior to mount removal.
4. Remove mount bolts and nuts.
5. Remove mount.
6. Position new mounts and re-install bolts
and nuts. See Section 11.6.
11.9 Hydraulic Motor
11.9.1 Hydraulic Motor Service
There are no user-serviceable parts in the
hydraulic motor. Contact the Allied
Technical Service Department for further
information.
11.9.2 Motor Rotation
The hydraulic motor is designed to rotate
in a single direction only. When viewing
the motor shaft with the large portion of
the motor downward, the correct rotation is
clockwise. In this orientation, the oil input
port is on the left side and output port is on
the right side.
IN OUT
27