Allied HO-PAC 1000 Series, Техническое руководство, Страница: 25 / 50

1000 Series Ho-Pac
SECTION 9.0
OPERATION
9.1 Preparation for Operation
1. Daily before operating, remove excess
dirt and debris from Ho-Pac. Excessive dirt
on the Ho-Pac can decrease performance.
2. Daily before operating, carefully
inspect:
a. Spring mounts for cracks and other
damage. Refer to Section 11.8.
b. Hoses and fittings for leaks and other
damage.
c. Unit for oil leaks. If leaks are evident,
check the oil level and fill as required, and
check bolt torques at oil gasket locations.
Refer to Sections 11.5 and 11.6.
d. Threaded fasteners, boom pins, and
mounting hardware for damage. Refer to
Section 11.6
3. Repair or replace any damaged
components prior to operation.
!! WARNING !!
Wear ear protection as required by
federal and local regulations.
!! CAUTION !!
At temperatures below 32
o
F (0
o
C),
operate the Ho-Pac for a few minutes
without down force to allow the spring
mounts to warm.
!! CAUTION !!
Do not operate Ho-Pac with hydraulic
oil temperature above 180
o
F (80
o
C) or
pressures above the values specified in
Section 4.1.
!! CAUTION !!
Do not operate the Ho-Pac underwater.
Bearing damage may result.
!! CAUTION !!
Do not use the Ho-Pac to move
materials. Ho-Pac damage may result.
9.2 Operation
The Ho-Pac is designed to operate with the
carrier over a wide range of temperatures.
Refer to the carrier’s recommendations for
operating temperature range.
1. Position carrier in-line with direction of
work.
!! CAUTION !!
Do not operate the Ho-Pac without base
plate. A dynamic imbalance and
equipment damage may result.
2. Position the Ho-Pac base plate parallel
to the work surface and within view of the
operator. The base plate must be in full
contact with the work surface for
maximum effectiveness.
!! WARNING !!
Never activate the Ho-Pac unless the
operator is seated in the operator’s seat
and in full control of the machine. Refer
to carrier’s instructions.
21