Allied Telesis IX5-28GPX, Справочник по командам, Страница: 459 / 2231

C613-50152-01 Rev C Command Reference for IX5-28GPX 459
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
S
WITCHING
C
OMMANDS
SPEED
speed
Overview This command changes the speed of the specified port. You can optionally specify
the speed or speeds that get autonegotiated, so autonegotiation is only
attempted at the specified speeds.
To see the currently-negotiated speed for ports whose links are up, use the show
interface command. To see the configured speed (when different from the
default), use the show running-config command.
Syntax
speed {10|100|1000|10000}
speed auto [10] [100] [1000] [10000]
The following table shows the speed options for each type of port.
Mode Interface Configuration
Default By default, ports autonegotiate speed.
Usage Switch ports in a static or dynamic (LACP) channel group must have the same port
speed and be in full duplex mode. Once switch ports have been aggregated into a
channel group, you can set the speed of all the switch ports in the channel group
by applying this command to the channel group.
NOTE
: If multiple speeds are specified after the auto option to autonegotiate speeds,
then the device only attempts autonegotiation at those specified speeds.
Examples To set the speed of a tri-speed port to 100Mbps, enter the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# speed 100
To return the port to auto-negotiating its speed, enter the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# speed auto
Port type Speed Options (units are Mbps)
RJ-45 copper ports
auto
(default)
10
100
1000
10000Mbps fiber SFP+
auto
(default)
10000