Allied Telesis IX5-28GPX, Справочник по командам, Страница: 1518 / 2231

C613-50152-01 Rev C Command Reference for IX5-28GPX 1518
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
V
IRTUAL
C
HASSIS
S
TACKING
(VCS
TACK
™) C
OMMANDS
SWITCH PROVISION
(
STACK
)
switch provision (stack)
Overview This command enables you to provide the configuration for a new stack member
switch prior to physically connecting it to the stack. To run this command, the stack
position must be vacant. The selected hardware type must be compatible existing
stack hardware.
Use the no variant of this command to remove an existing switch provision.
Syntax switch < stack-ID > provision IX5-28
no switch < stack-ID > provision
Mode Global Configuration
Usage Note that although the syntax appears to allow provisioning on up to 8 stackable
switches, in practice a maximum of 4 are configurable. Normally the stack
members would be numbered 1 to 4, and so the command could be run to
provision any stack member within this range; and we advise this procedure. In
effect, the syntax then becomes:
switch < 1-4 > provision IX5-28
However, you could number the stack units with any numbers between 1 and 8.
For example you could number your four stack members 1, 2, 7 and 8. In this case
you could provision any of the stack members within this range. We advise against
numbering your stacks in this way.
Examples To provision an IX5-28 switch as stack member 3, use the following commands:
awplus# configure terminal
awplus(config)# switch 3 provision IX5-28
To remove the provision of the IX5-28 switch as stack member 3, use the following
commands:
awplus# configure terminal
awplus(config)# no switch 3 provision
Related
Commands
show provisioning (stack)
show stack
Parameter Description
<stack-ID>
Stack member number, from 1 to 8.
provision
Provides settings within the stack configuration ready for a
specific switch type to become a stack member.
IX5
Provision a 28-port IX5 switch.