Allied Telesis AT-GS2002 Series, Руководство по установке

Страница: 48 / 96

Chapter 2: Installing the Bridging Converter
48
4. Power ON the converter as instructed in “Powering On the Bridging
Converter” on page 50.
5. Power ON the end-nodes.
Connecting to the Copper Port
To connect to the RJ-45 twisted pair port on the AT-GS2002 Series
converter, perform the following procedure:
1. Connect the RJ-45 twisted pair cable to the 10/100/1000Base-TX
port, as shown in Figure 20.
Figure 20. Connecting to the RJ-45 Copper Ports
When connecting a twisted pair cable to an RJ-45 twisted pair port,
observe the following guidelines:
ˆ
An RJ-45 connector should fit snugly into the port on the converter.
The tab on the connector should lock the connector into place.
ˆ
You can use a straight-through or crossover twisted pair cable to
connect any type of network device to a port on the converter.
2. Then connect the other end of the RJ-45 cable to the link partner.
3. Power ON the converter as instructed in “Powering On the Bridging
Converter” on page 50.
4. Power ON the end-nodes.
354
002
GIGABIT BRIDGING CONVERTER
1000Bas
e
ML
SML
LT
MODE
10/100/1000 Base-
T
PWR
AU
TO
NEG
1000M
LINK
AC
T
100M
PO
RT
2
1
TX
RX
AU
TO M
DI/M
DI-
X