Installation
18
Media Module Installation
ATM Physical Media Modules are available in several versions for
differing network requirements.
Installing ATM Media Modules
ATM Media Modules plug into the Media Channel connector located on
the AT-4016F back panel.
Attention
You must disconnect the AT-4016F from its power source to install or swap
ATM Media Modules.
1.
Disconnect the AC power cord from the AT-4016F.
2.
Unplug any data cables connected to the current ATM Media Module.
(If no ATM Media Module is currently installed, skip this step.)
3.
Unscrew the screws at the outer edges of the current module’s faceplate
(or blank faceplate, if no module is currently installed).
4.
If you are replacing a module, unplug the current module from the
AT-4016F’s 96-pin ATM Media card connector and slide it out from the
housing (see Figure 14).
5.
Carefully insert the new module until it plugs into the ATM Media card
connector and its faceplate is flush with the AT-4016F housing.
6.
Tighten the two screws to secure the new module.
7.
Reconnect the AC power cord to power on the system.
Figure 14: Replacing an ATM
Media Module
